Rapid Response Plumber of Garland
Backflow Prevention Testing Garland, TX
Backflow prevention testing in Garland checks that the device keeping irrigation water out of your drinking water still works. From Broadway Blvd, 8 AM until 8 PM every day, we explain what the test involves, who may legally carry it out and the price before the assembly is touched.
- Price first, work second
- Tested before the plumber leaves
What backflow prevention testing involves
Backflow is water running the wrong way: out of a sprinkler system, or a hose left lying in a bucket of weed killer, and back into the pipes that feed your kitchen tap. It happens when pressure in the city main drops suddenly, from a broken main or heavy firefighting nearby, and siphons water backward. A backflow assembly is a pair of check valves, sometimes with a relief valve between them, that allows flow in one direction only. Lawn sprinkler systems in Texas are required to have one, usually in a small box in the ground or standing above it near the house.
Testing means connecting a calibrated gauge to the test ports on the assembly and checking that each valve holds, and opens, at the right pressure. Texas allows only someone holding the state's backflow assembly tester license, issued by TCEQ, the environmental agency, to perform it, and the results go on a report for your water utility. When an assembly fails, the usual causes are worn rubber parts, debris on a seat or freeze damage, and many can be rebuilt rather than replaced.
When an assembly needs testing
- A notice from your city's water department saying a test is due
- A sprinkler system that is brand new or freshly repaired
- an assembly that froze in a hard winter, or has a cracked body
- Water dripping or spraying from the device while the sprinklers are off
- A house purchase where the irrigation system's history is unknown
On site
How the visit goes
Find the assembly
The device is located, its type and size recorded, and the test ports checked.
Test each valve
A tester holding the state license connects a calibrated kit and checks each valve against the required pressures.
Report the result
Pass or fail, you hear the result, and the report is prepared for the water utility.
Price any repair
If the assembly fails, you hear why and the price to rebuild or replace it, and it is tested again after the repair.
Local conditions
Backflow Prevention Testing in Garland
Garland homes that water their lawns through an in-ground sprinkler system will almost always have a backflow assembly somewhere on that line. How often it must be tested is set by the city's water department, not by this page: some cities ask for a test only when a device is installed or repaired, others every year. if you have received a notice, it gives the deadline. A hard freeze can split the brass body of an above-ground assembly, so wrap it before cold weather arrives.
Backflow Prevention Testing: what people ask first
Do I need a backflow test?
If your water utility has sent a notice, yes, by the date on it. Otherwise an assembly is tested when it is first installed and again after any repair.
Who is allowed to test it?
Only someone holding the TCEQ license for backflow assembly testing, and that license number goes on the report.
What does a failed test mean?
That one of the valves inside is not holding, usually because of worn rubber, debris or freeze damage. It does not mean your water is contaminated, but the device should be repaired and tested again.
How to book backflow prevention testing in Garland
Have the city's notice to hand, with its deadline and any make, size or serial number it lists for the assembly. Call (972) 627-4926, 8 AM until 8 PM seven days a week, and say where the device is and whether the sprinklers have been leaking.
Ready to book? The price comes first.
Say what you are seeing and what you have already shut off. The cause and the cost are explained before a tool comes out.
