Daily 8 AM–8 PMWater running? Close the main shut-off first.

Rapid Response Plumber of Garland

Backflow Prevention Testing Mesquite, TX

Backflow prevention testing in Mesquite follows a city ordinance, not a one-size schedule. Before a gauge is connected, you hear which test your assembly actually needs under that ordinance, who is allowed to perform it, and what it will cost. Rapid Response Plumber's office is up the road in Garland, on Broadway Blvd.

Mesquite homes and backflow prevention testing

The city's backflow ordinance treats houses differently from everything else. Every non-residential assembly is tested when it goes in and again every year after that, but a residential assembly is tested upon installation. For most homeowners, then, the test that counts is the one when a new sprinkler system, or a replacement assembly, is put in. the city's installation guide calls for a double check assembly on residential irrigation, often set below grade in a small box close to the house.

The test itself has a city witness. Only a tester on Mesquite's own registration list may do it, that tester has to contact the Public Works Backflow Inspector first, and the inspector has to be there to watch. Backflow and irrigation contractors also need a city Professional License, the same registration Mesquite asks of plumbers before any permit. So a test is scheduled around the inspector's calendar as well as yours, and it is worth booking early when a new system is going in. If an assembly fails, it is repaired or replaced, and the retest arrangements should be confirmed with the inspector before anyone comes back out.

Backflow rarely comes up on its own. Installing a lawn sprinkler system in Mesquite needs an irrigation permit, and every new system must have a rain and freeze sensor on its controller. The city's current rules also hold lawn watering to once a week through the winter months, November to March, with no outdoor watering at all during rain or a freeze. A sensor stops the sprinklers in the cold, but a brass assembly standing above the ground should still be wrapped ahead of a hard freeze, because a body full of water can split. A system put in before the sensor rule may have none; adding one to the controller is a small job.

When an assembly needs testing

  • A notice from your city's water department saying a test is due
  • A sprinkler system that is brand new or freshly repaired
  • An assembly that froze in a hard winter, or has a cracked body
  • Water dripping or spraying from the device while the sprinklers are off
  • A house purchase where the irrigation system's history is unknown

Questions from Mesquite

Does my Mesquite sprinkler backflow device need testing every year?

Not under the city's ordinance: a residential assembly needs its test at installation, and the yearly retest applies to other properties. If a city notice tells you otherwise, follow the notice and its deadline. A new or replacement device is tested when it goes in, and testing one after freeze damage is a sensible precaution.

Why does Mesquite care about a backflow device on my lawn?

Because every house shares the same drinking water. Mesquite's comes from Lavon Lake via North Texas Municipal Water District treatment, then moves through the city's own pumping stations, storage tanks and mains. A sprinkler line holds fertilizer, weed killer and standing water. If pressure in a main drops suddenly, that water could be pulled backward into the supply without a working assembly.

Do I need a backflow test?

If your water utility has sent a notice, yes, by the date on it. Otherwise an assembly is tested when it is first installed and again after any repair.

Booking in Mesquite

Have the city's notice to hand, with its deadline and any make, size or serial number it lists for the assembly. call (972) 627-4926, 8 AM until 8 PM seven days a week, and say where the device is and whether the sprinklers have been leaking.

Backflow Prevention Testing in other cities

Something leaking? Start with the valve.

Call now