Rapid Response Plumber of Garland
Backflow Prevention Testing Richardson, TX
Backflow prevention testing in Richardson is priced before the test kit comes out, and nothing beyond the test, no repair and no new part, happens until you agree to it. If the assembly fails, the plumber explains which part failed, why, and what each way of fixing it would cost.
Richardson homes and backflow prevention testing
Backflow protection exists to keep yard water out of the drinking water. Richardson buys its treated supply from NTMWD and delivers it through roughly 584 miles of mains, and a lawn sprinkler connected without protection could pull fertilizer and soil back into that system. For homeowners, the city's published backflow rules center on lawn irrigation: a new assembly gets its first test at installation, and the City Cross Connection Inspector then inspects it within ten business days, before the sprinklers go into service. The city's water system holds a Superior rating from the TCEQ, and backflow devices are one of the ways it stays protected.
Richardson's irrigation code adds a yearly test for devices that guard against a health hazard; a double check valve, the usual choice where no such hazard exists, is tested when installed. Testers must register and upload each report, along with the CSI forms, to SC Tracking Solutions, the system the city uses for backflow records. the assembly itself must sit on private property, on the house side of the sidewalk, with an isolation valve ahead of it. An assembly found on the street side of the sidewalk does not match that rule, so ask what the city expects before repairing it.
Repairs come with conditions. When an existing sprinkler system is repaired, the city requires a rain/freeze sensor, and a system without a backflow assembly must get one before any major maintenance, alteration or repair. The sensor also keeps you within the watering rules: no watering in rain or freezing weather, with even-numbered addresses on Tuesday and Saturday and odd ones on Wednesday and Sunday. An above-ground assembly can crack its body in a hard freeze, and February 2021 brought exactly that, so look it over before the first watering day of spring.
When an assembly needs testing
- A notice from your city's water department saying a test is due
- A sprinkler system that is brand new or freshly repaired
- an assembly that froze in a hard winter, or has a cracked body
- Water dripping or spraying from the device while the sprinklers are off
- A house purchase where the irrigation system's history is unknown
Questions from Richardson
I'm putting in a new sprinkler system. What does Richardson require?
A Lawn Sprinkler permit, taken out by an irrigator who is registered with the city, and a backflow assembly on your side of the sidewalk with an isolation valve. Once it is installed, the assembly is tested, the tester files the results through the city's tracking system, and the city's inspector checks it before the system goes into service. Later repairs bring in the sensor rule.
Does the backflow device on an older sprinkler system need testing?
That depends on the device and on any letter you have received. If it protects against a health hazard, the city's irrigation code calls for a test every year after installation. If the old system has no assembly at all, one has to be added before any major repair. If the city has written to you about a test, the date in that letter is the one to meet.
Do I need a backflow test?
If your water utility has sent a notice, yes, by the date on it. Otherwise an assembly is tested when it is first installed and again after any repair.
Booking in Richardson
Have the city's notice to hand, with its deadline and any make, size or serial number it lists for the assembly. Call (972) 627-4926, 8 AM until 8 PM seven days a week, and say where the device is and whether the sprinklers have been leaking.
