Rapid Response Plumber of Garland
Faucet Installation Garland, TX
Faucet installation in Garland is easiest when the faucet and the sink are matched before anything is bought. We work 8 AM until 8 PM every day from Broadway Blvd, and the plumber checks the holes, valves and supply lines and quotes the job before the old faucet comes off.
- Price first, work second
- Tested before the plumber leaves
What faucet installation involves
Sinks are drilled for a set number of holes, usually one, three or four, and the spacing between them matters. A single-hole faucet can go on a three-hole sink with a cover plate; a widespread faucet needs holes eight inches apart. A pull-down kitchen sprayer also needs room in the cabinet for its hose to drop and its weight to hang. A look under the sink with a flashlight saves buying the wrong faucet.
The old faucet is removed, which on an older sink can mean cutting through corroded nuts. The sink surface is cleaned, and the new faucet is mounted, sealed and connected with new braided supply lines. The shut-off valves are checked too, because a valve that will not close fully makes every future repair harder. Then the aerator is taken off and the lines flushed, so any debris goes down the drain rather than into the new cartridge.
Reasons to replace a faucet
- The body or base of the faucet leaks, not just a cartridge
- Parts are no longer made for the old model
- The finish is peeling, pitted or crusted with scale
- A kitchen remodel, a new sink or new countertops
- A wish for a taller spout, a touchless faucet or a pull-down sprayer
On site
How the visit goes
Check the fit
The sink holes, their spacing and the cabinet space are checked against the faucet you have or want.
Price it
You hear the price, including new supply lines and any valve that needs replacing.
Remove and mount
Off comes the old faucet; the deck is scrubbed, and the new one is set, sealed and hooked up.
Flush and test
The lines are flushed, the aerator refitted, and hot and cold run while every joint is checked for drips.
Local conditions
Faucet Installation in Garland
in Garland homes from the 1950s to the 1970s, the shut-off valves under the sinks are often original, and many no longer close completely or start to drip when turned. A faucet replacement is the easiest moment to change them. The hard water here also leaves scale on new faucets over time, so it pays to choose a model whose cartridges are easy to buy.
Faucet Installation: what people ask first
Should I buy the faucet before the visit?
You can, as long as it matches the number of holes in your sink and their spacing. Count the holes, or look under the sink, before you shop, and keep the receipt in case it does not fit.
Do I need new supply lines?
Usually, yes. Old braided or plastic lines stiffen and crack with age, and new ones cost little next to the damage a burst line can do inside a cabinet.
What if the old faucet will not come off?
Corroded mounting nuts are common on older sinks. They can be cut off without harming the sink, which is part of why the plumber looks under the cabinet before pricing the job.
How to book faucet installation in Garland
Count the holes in the sink before you call, and check whether the valves underneath close all the way. call (972) 627-4926, 8 AM until 8 PM any day, and say which sink it is and if the faucet is already bought.
Ready to book? The price comes first.
Say what you are seeing and what you have already shut off. The cause and the cost are explained before a tool comes out.
