Daily 8 AM–8 PMWater running? Close the main shut-off first.

Rapid Response Plumber of Garland

Whole Home Repiping Plano, TX

Whole home repiping in Plano opens walls only at the spots you have approved, and the plumber leaves each work area clean. Before the first cut you see the route the new lines will take, the timetable and the total cost, and nothing starts until you agree to all three.

Plano homes and whole home repiping

Plano's busiest building years line up with the years polybutylene was in use. Some 29 percent of Plano's housing dates from the 1990s and 22 percent from the 1980s, which puts the median at 1993, and a share of houses from the late 1970s into the mid 1990s received that gray plastic pipe. Its fittings tend to fail, often several within a few years. Copper under the slab in homes of the same era is the other common reason to repipe, especially after a second slab leak.

Plano's completed service line inventory came back with no lead service lines across the city's system, but that survey stops where the line reaches the house. It says nothing about the pipe inside the walls, and that is the part a repipe replaces. In most repipes the new lines travel across the attic and drop through the walls to each fixture, which leaves the slab out of it. Attic runs need good insulation against cold like February 2021, and PEX tolerates water freezing inside it better than copper does. ask for a fresh main valve where the supply enters as part of the plan, so you have one that turns when it matters.

A repipe is plumbing work, which the city's permit guide puts on its list of projects requiring one, and the city inspects the new piping before the job is closed out. only plumbing contractors registered in Plano, renewing each year with a current Texas license, can pull that permit for you; a homeowner may apply for one on their own residence. Inspections are booked through eTRAKiT, and openings usually stay uncovered until the work has been inspected, so ask how that fits the schedule before any wall is opened.

When repiping is worth discussing

  • Leak number three in a few years, each in a different room
  • Gray polybutylene or threaded galvanized pipe anywhere in the system
  • Weak flow at every tap in the house at once
  • Brown or orange water when a tap is first opened
  • A second slab leak, or a slab leak on a line that was already repaired

Questions from Plano

What does polybutylene look like in a Plano house?

Check wherever pipe is exposed: under sinks, at the water heater and where the main comes into the house. Polybutylene is flexible, usually gray, and joined with metal crimp rings; some is stamped PB2110. Copper is reddish metal, and PEX is red, blue or white plastic printed with its name. If your house went up in the late seventies, the eighties or the early nineties, as a large slice of Plano did, it is worth checking.

Are there city rebates on anything installed with a repipe?

Two may apply. Houses built before 2013 in areas the city's map shows above 80 psi can claim part of the cost of a pressure reducing valve back from the city, installed by a plumber registered in Plano. Houses from 1994 or before can get rebates on up to three WaterSense toilets rated at 1.28 gallons or less per flush. Both require buying from a retailer in Plano and applying within 120 days.

Can we stay at home during a repipe?

Most households stay put. Water is shut off just while each new section gets tied in, and the schedule shows which days a bathroom or the kitchen is out of action. You see that schedule before the work begins.

Booking in Plano

Call (972) 627-4926 from 8 AM until 8 PM, any day. It helps to know roughly when the house was built, how many leaks there have been and where, and what the pipe looks like below a sink or beside the water heater. The number of bathrooms shapes the plan and the schedule, so have that ready too.

Whole Home Repiping in other cities

Something leaking? Start with the valve.

Call now